Setup guide
How to set up your ESB2 on the range
The ESB2 pairs with the free ES Range app on your phone or tablet, where your numbers appear — it has no built-in screen. From opening the box to your first measured shot takes about five minutes.
Step 1. Charge the unit fully
Use the supplied cable. A full charge takes about three hours and gives you roughly twenty hours of use.
Step 2. Position the unit behind the ball
Place the ESB2 four to six feet directly behind the ball, square to your target line. Use the tripod on uneven ground.
Step 3. Power on and select your club
Press and hold the power button, then use the club selector so the unit applies the right expectations to the shot.
Step 4. Pair the free ES Range App
Open the ES Range app on your phone or tablet, enable Bluetooth, and select ESB2 — this is where your numbers appear, since the ESB2 has no built-in screen.
Step 5. Hit a shot and read the app
Ball speed, club speed, carry, total, smash factor, spin and launch angle appear in the app within about a second of each shot. Session history and practice plans live there too.
If something is not working
If the unit is not reading shots, check that nothing is blocking the sensor window and that you have at least four feet of clearance behind the ball.